Loosen the 3 screws using a 2mm allen wrench. Remove the skid plate.
STEP 2
Loosen the 2 screws using a 2.5mm allen wrench. Remove the retainer, servo saver spring and center guidepost.
STEP 3
Remove the plastic steering arm. Then remove the servo horns.
STEP 4
Install with the aluminum steering arm (shown as connected to the right servo but designed to be used with either servo). Connect the steering linkage with the steering arm using existing screw.
Tip: Use a servo horn that will allow the steering linkage to sit parallel to the servo.
STEP 5
Install the center guidepost, servo saver spring and spring retainer.
STEP 6
Install the skid plate with existing screws.
REVO®, JATO®, T-MAXX®, etc. are registered trademarks of Traxxas® L.P.
Tip: Use a servo horn that will allow the steering linkage to sit parallel to the servo.
